Up for sale is a brand new Trianglelab PT1000 Pro Thermistor Cartridge. This hightemperature cartridge can reach up to 450C for 3D printers using Volcano, Rapido,Dragon and many other hotends. Print advanced materials such as carbon fiber blendswith consistent high temperatures.
IMPORTANT: PT1000 sensor is notcompatible with the Lerdge K motherboard
Technical Details:
Full specifications can be found onTriangle-Lab’s website or their direct Google Drive Link: style="">
Marlin Firmware Configuration:
Connect directly to the thermalinterface of the control board and then determine which resistor to chooseaccording to the resistors listed. In most cases it is 4.7K ohms, please checkyour motherboard manual for details.
* 1010 : Pt1000 with 1kΩ pullup
* 1022 : Pt1000 with 2.2kΩ pullup
* 1047 : Pt1000 with 4.7kΩ style="">
Klipper documentation:
Directly connect the PT1000 sensor.The following parameters are available in heater sections that use one of thesesensors.
sensor_type: PT1000
sensor_pin:
# Analog input pin connected to thesensor. This parameter must be
# provided.
#pullup_resistor: 4700
# The resistance (in ohms) of thepullup attached to the sensor. The
# default is 4700
