Brand New HP Motherboard Holly AAHD2-HY 660155-001 657134-003 AMD Hudson-D2 FM1
THE ITEM INCLUDES JUST THE BOARD. NO ACCESSORIES ARE INCLUDED.
Model: AAHDY-HY
HP/Compaq name: Holly
Form factor: uATX: 24.38 cm (9.6 inches) x 24.38 cm (9.6 inches)
Chipset: AMD Hudson-D2 FCH
Front Side Bus Speed: 100 MHz UMI (United Media Interface)
CPU Support:
·65W to 100W (processor dependent)
·Socket type: FM1
·Motherboard supports the following processor upgrades:
Processor
TDP
AMD A8-3850 (Liano) quad core
100W
AMD A8-3800 (Liano) quad core
65W
AMD A6-3650 (Liano) quad core
100W
AMD A6-3600 (Liano) quad core
65W
AMD A4-3400 (Liano) dual core
65W
AMD E2-3200 (Liano) dual core
65W
Memory upgrade:
·Dual channel memory architecture
·Two 240-pin DDR3 DIMM sockets
·Supports DDR3 DIMMs
o PC3 10600 (1333 MHz)
o PC3 12800 (1600 MHz)
o PC3 14400 (1866 MHz)
·Non-ECC memory only, unbuffered
·Supports 1 GB, 2 GB or 4 GB DIMMs
·Supports up to 4 GB on 32-bit* systems
·Supports up to 8 GB on 64-bit systems
NOTE:*32-bit systems cannot address a full 4.0 GB of memory
Video:
*Integrated video is not available if a graphics card is installed.
·Supports PCI Express x16 graphics cards
·DVI and VGA ports (Use of both the VGA and DVI ports at the same time is supported)
Model
Radeon graphics brand
TDP
AMD A-Series Processors
A8-3850
HD 6550D
100W
A8-3800
HD 6550D
65W
A6-3650
HD 6530D
100W
A6-3600
HD 6530D
65W
A4-3400
HD 6410D
65W
AMD E-Series Processors
E2-3200
HD 6370D
65W
Audio:
·Built-in High Definition 5.1 channel audio
·Audio codec: Realtek ALC 656
Network, integrated 1000 Base-T:
·Interface: PCI Express x1
·Technology: Realtek RTL8111E gigabit ethernet controller
·Data transfer speeds: up to 10/100/1000 Mb/s
·Transmission standards: 1000-Base-T Ethernet
Expansion slots:
PCI-Express Generation 2 speed
·One PCI Express x16
·Three PCI Express x1
·One PCI Express mini card
I/O Ports:
1 - DVI-D
2 - VGA
3 - USB 2.0: 4
4 - LAN
5 - Audio: Line In port (light blue)
6 - Audio: Line Out port (lime)
7 - Audio: Microphone port (pink)
Internal connectors:
·1x ATX power connector
·1x ATX CPU power connector
·1x System FAN connector
·6x SATA 2.0 connectors
·1x ROM recovery connector
·1x Front panel audio connector
·1x FDO connector
·1x Front panel connector
·4x USB 2.0 connectors
Motherboard layout:
Clearing CMOS settings:
CAUTION: Do not change any jumper setting while the computer is on. Damage to the motherboard can result.
This motherboard has a jumper to clear the Real Time Clock (RTC) RAM in CMOS.
1. Turn OFF the computer and unplug the power cord.
2. Move the jumper to clear for 5 to 10 secs, then move the jumper back to default.
3. Plug the power cord and turn ON the computer.
4. On the next startup, enter BIOS setup to re-enter user settings.
Clearing password settings:
The BIOS password is used to protect BIOS settings from unwanted changes.
To erase the BIOS password follow these steps:
1. Turn OFF the computer.
2. Move the jumper to Clear.
3. Turn ON the computer to POST screen
4. Turn OFF the computer.
5. Move the jumper back to Default
6. Enter BIOS setup to verify or configure new settings
