Unlike Bambu Lab, Prusa is open source 3d printer. Not locked to a specific slicer.

This is a custom built Bear Edition Prusa Mini. If you’re familiar with Prusa you’re familiar with the Bear Frame upgrade.

Upgraded 220W power supply

Dual Z axis motors

Linear Rail X Axis

Increased Z axis from 180 to 200mm

Stiffer Bear frame

Direct Dual gears BondTech extruder

Hardened Revo hot-end

Dual hot-end cooling

Prorifi3D motors to eliminate VFAs

Custom LED lights on top

Calibrated with accelerometer

Fresh custom-edited firmware with input shaping and WiFi

Comes with extra plates and nozzles

Note the smooth sheet from prusa is not included. I’m including a new biqu glacier bite plate. Not the orange one in the picture.