TESTING & COSMETIC NOTES:
This is a USED WORKING item in GOOD cosmetic condition that IS THOROUGHLY TESTED and is GUARANTEED WORKING
These units have been reset to the factory default settings. See console log below.
COMPONENTS INCLUDED IN THIS sale:• (2) - CISCO CATALYST WS-C2960X-24TS-L 24-PORT GIGABIT MANAGED ETHERNET SWITCH
• (2) - POWER CORD
REPLACEMENT or MONEY BACK GUARANTEE:When you receive a Guaranteed item from OC Depot, it should perform as described. In the rare situation that this is not the case, we will send a replacement upon safe return of the original item within 30 days of receiving the item. If a replacement is not available we will honor the terms of our Money-Back Guarantee.
ADDITIONAL INFORMATION:Loading />File />executing...
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX4,)
Technical Support: http:/www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Thu 14-Nov-13 11:33 by prod_rel_team
HULC:Collect Entropy thread starting on box...
Initializing flashfs...
Using driver version 3 for media type 1
mifs[7]: 10 files, 1 directories
mifs[7]: Total bytes : 1806336
mifs[7]: Bytes used : 690688
mifs[7]: Bytes available : 1115648
mifs[7]: mifs fsck took 1 seconds.
mifs[7]: Initialization complete.
mifs[8]: 0 files, 1 directories
mifs[8]: Total bytes : 3870720
mifs[8]: Bytes used : 1024
mifs[8]: Bytes available : 3869696
mifs[8]: mifs fsck took 0 seconds.
mifs[8]: Initialization complete.
mifs[9]: 5 files, 1 directories
mifs[9]: Total bytes : 258048
mifs[9]: Bytes used : 8192
mifs[9]: Bytes available : 249856
mifs[9]: mifs fsck took 0 seconds.
mifs[9]: Initialization complete.
mifs[10]: 5 files, 1 directories
mifs[10]: Total bytes : 258048
mifs[10]: Bytes used : 8192
mifs[10]: Bytes available : 249856
mifs[10]: mifs fsck took 0 seconds.
mifs[10]: Initialization complete.
mifs[11]: 625 files, 21 directories
mifs[11]: Total bytes : 122185728
mifs[11]: Bytes used : 23721984
mifs[11]: Bytes available : 98463744
mifs[11]: mifs fsck took 1 seconds.
mifs[11]: Initialization complete.
...done Initializing flashfs.
FIPS: Flash Key Check : Begin
FIPS: Flash Key Check : End, Not Found, FIPS Mode Not Enabled
POST: MA BIST : Begin
POST: MA BIST : End, Status Passed
POST: TCAM BIST : Begin
POST: TCAM BIST : End, Status Passed
POST: ACT2 Authentication : Begin
POST: ACT2 Authentication : End, Status Passed
extracting front_end/front_end_ucode_info (43 bytes)
Waiting for Stack Master Election...
POST: Thermal, Fan Tests : Begin
POST: Thermal, Fan Tests : End, Status Passed
POST: PortASIC Stack Port Loopback Tests : Begin
POST: PortASIC Stack Port Loopback Tests : End, Status Passed
POST: PortASIC Port Loopback Tests : Begin
POST: PortASIC Port Loopback Tests : End, Status Passed
POST: EMAC Loopback Tests : Begin
POST: EMAC Loopback Tests : MAC Loopback Passed
POST: EMAC Loopback Tests : PHY Loopback Passed
POST: EMAC Loopback Tests : End, Status Passed
Election Complete
Switch 1 booting as Master
Waiting for Port download...Complete
Initializing Port Extension Feature Support...
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco WS-C2960X-24TS-L (APM86XXX) processor (revision B0) with 524288K bytes of.
Processor board ID FOC1813S0PM
Last reset from power-on
1 Virtual Ethernet interface
1 FastEthernet interface
28 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:E1:6D:41:23:00
Motherboard assembly number : 73-14194-04
Power supply part number : 341-0529-02
Motherboard serial number : FOC181300KC
Power supply serial number : LIT18070MV6
Model revision number : B0
Motherboard revision number : A0
Model number : WS-C2960X-24TS-L
Daughterboard assembly number : 73-14200-03
Daughterboard serial number : FOC18127A07
System serial number : FOC1813S0PM
Top Assembly Part Number : 800-38008-02
Top Assembly Revision Number : C0
Version ID : V02
CLEI Code Number : CMMMU00ARA
Daughterboard revision number : A0
Hardware Board Revision Number : 0x05
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 28 WS-C2960X-24TS-L 15.0(2)EX4 C2960X-UNIVERSALK9-M
Press RETURN to get started!
*Mar 1 00:00:23.641: Read env variable - LICENSE_BOOT_LEVEL =
Mar 30 01:27:38.146: Module name
May 23 15:30:08.272: in Switch 0. Cannot read pid from Flexstack module
May 23 15:30:59.984: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the sk
May 23 15:31:01.302: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, chan
--- System Configuration Dialog ---
Enable secret warning
----------------------------------
In order to access the device manager, an enable secret is required
If you enter the initial configuration dialog, you will be prompted for the enat
If you choose not to enter the intial configuration dialog, or if you exit setu,
please set an enable secret using the following CLI in configuration mode-
enable secret 0
----------
May 23 15:31:01.302: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernn
May 23 15:31:03.007: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for typn
May 23 15:31:25.007: %STACKMGR-5-SWITCH_READY: Switch 1 is READY
May 23 15:31:25.007: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 1 has c-
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
Would you like to enter the initial configuration dialog? [yes/no]: DOWN
May 23 15:31:25.007: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 1 has cN
May 23 15:31:25.286: %STACKMGR-5-MASTER_READY: Master Switch 1 is READY
May 23 15:31:25.297: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX4,)
Technical Support: http:/www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Thu 14-Nov-13 11:33 by prod_rel_team
May 23 15:31:27.285: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to n
May 23 15:31:29.543: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45.
% Please answer 'yes' or 'no'.
Would you like to enter the initial configuration dialog? [yes/no]: n
Switch> Please Click Here to Visit Our StoreSearchBy37 - 261092 | Loc: E36 | L: Mitchell |T: | PM: Nick | QTY: 0| Plan: L FREESHIP - 20LBS |22.00"x15.00"x7.00"27.00lbs |Start: $0.00 | BIN: $109.99 | |2024-05-24 ||88758
