HT-NTC100K Thermistor Temperature Sensor – 3-Pack

This listing is for a 3-piece set of HT-NTC100K thermistor sensors used to measure hotend temperature on common FDM 3D printers. Designed as a direct-replacement style sensor for printers that use NTC 100K thermistors.

Ideal for fixing inaccurate temperature readings, thermal errors, or broken factory sensors.

🔧 COMMON PROBLEMS THIS FIXES

• Incorrect hotend temperature readings

• Thermal runaway or heating errors

• Failed prints due to temperature fluctuation

• Broken, frayed, or brittle thermistor wires

⚙️ FEATURES

• NTC 100K resistance thermistor

• High-temperature rated sensor design

• Pre-wired leads for easy installation

• Compact probe size fits standard hotend blocks

• Stable and consistent temperature response

• Direct replacement style (no modification to sensor required)

🖨️ COMPATIBILITY

FOR 3D printers that use NTC 100K hotend thermistors, including:

• Ender 3

• Ender 3 V2

• Ender 5

• CR-10 series

• Other FDM printers using NTC 100K sensors

⚠️ Not universal.
Confirm resistance type, connector style, and wire length before purchase.

📐 SPECIFICATIONS

• Sensor Type: NTC Thermistor

• Resistance: 100K Ohm

• Connector: 2-Pin (XH2.54 style)

• Lead Length: Approx. 1 meter per sensor

• Installation Location: Hotend

📦 WHAT YOU RECEIVE

• (3) HT-NTC100K thermistor temperature sensors

Only items shown are included.
No hotend, heater cartridge, or printer included.

⚠️ IMPORTANT NOTES (READ)

• Firmware configuration may be required depending on printer

• Installation experience recommended

• Not a complete hotend assembly

• Verify thermistor type before ordering to avoid returns