Brand NewKingston KVR1066D3E7K2/2G - 2GB 2x1GB DDR3 PC3-8500 ECC UNBUFFERED 240-Pins Memory
DESCRIPTION :ValueRAM's KVR1066D3E7K2/2G is a kit of two 128M x 72-bit(1GB) DDR3-1066 CL7 SDRAM (Synchronous DRAM), 1Rx8ECC memory modules, based on nine 128M x 8-bit FBGAcomponents per module. Total kit capacity is 2GB. The SPD'sare programmed to JEDEC standard latency DDR3-1066 timingof 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers.The electrical and mechanical specifications are as follows
CL(IDD) 7 cyclesRow Cycle Time (tRCmin) 50.63ns (min.)Refresh to Active/Refresh 110ns (min.)Command Time (tRFCmin)Row Active Time (tRASmin) 37.5ns (min.)Power (Operating) 1.147 W* (per module)UL Rating 94 V - 0Operating Temperature 0o C to 85o CStorage Temperature -55o C to +100o C• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply• VDDQ = 1.5V (1.425V ~ 1.575V)• 533MHz fCK for 1066Mb/sec/pin• 8 independent internal bank• Programmable CAS Latency: 8, 7, 6• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock• Programmable CAS Write Latency(CWL) = 6 (DDR3-1066)• 8-bit pre-fetch• Burst Length: 8 (Interleave without any limit, sequential withstarting address “000” only), 4 with tCCD = 4 which does notallow seamless read or write [either on the fly using A12 orMRS]• Bi-directional Differential Data Strobe• Internal(self) calibration: Internal self calibration through ZQpin (RZQ : 240 ohm ± 1%)• On Die Termination using ODT pin• Average Refresh Period 7.8us at lower than TCASE 85°C,3.9us at 85°C < TCASE < 95°C• Asynchronous Reset• PCB: Height 1.18” (30mm), single sided component
