SKRat V1.0 32bit 3D Printer Motherboard RatOS 2.0 Support CAN BUS ADXL345 PT100
Features: High 32-bit 64 MHz ARM Cortex-M0+ series STM32G0B1VET6 MCU
Onboard BOOT button to enable DFU to update the bootloader.
The thermistor circuit is protected to prevent MCU damage from shorted heated bed and heater cartridge connection.
Four 2-pin fan ports, always-on fan port, and two 4-pin fan ports.
All fans can realize VIN12V, 5V-voltage selection jumpers-, and different voltages can be set separately for different ports.
Integrated SPI- and UART of driver and DIAG- pin, easily configurable with jumpers-.
Supports power loss recovery, filament- runout auto power-off, BLTouch-, proximity RGB, etc.Onboard CAN bus port.Onboard UART and I2C expansion output ports.
The SPI- expansion port is +3.3V and +5V selectable, which is convenient to expansion modules, such as an ADXL345 accelerometer.Specifications: Item：SKRat V1.0 3D Printer Motherboard
MCU: 32-bit 64 MHz ARM Cortex-M0+ series STM32G0B1VET6
Onboard CAN Bus ADXL345 PT100
Support ADXL345 VIN12V/5V
With: 7 Fan Ports
Compatible：RatOS 2.0
For Klipper 3D Printer Control Includes: 1 PC SKRat V1.0 32bit 3D Control Boardnote: No retail package.
Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you offer.
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!